|
201DF--Slab Drawer Front, Soft Maple
| Slab Drawer Fronts (200 Series) are laminated from solid wood stock and require only specification of edge profile. | 
501VRP-DF--Veneer Raised Panel Drawer
Front, Soft Maple | 5-Piece, Cope & Stick Drawer Front with Veneer Raised Panel
(500 Series)
5 PC drawer faces follow the same naming protocol and standards as the door styles. | 
301FP-DF--Flat Panel Drawer Front, Red Oak | Cope & Stick Drawer Front with Flat Panel (300 Series).
Flat panel drawer fronts are often used alongside raised panel doors to allow a more generous field for hardware mounting. | 
501VRP-DF--Veneer Raised Panel Drawer
Front, Hickory | 5-Piece, Cope & Stick Drawer Front with Veneer Raised Panel
(500 Series)
5-Piece, Cope & Stick Drawer Front with Solid Wood Raised Panel
(100 Series, not pictured) | 
301 VRP-DF--Veneer Raised Panel Drawer
Front, Hickory | Designer Mitered Drawer Face with Flat Panel
(900 Series) | 
801DF-Vertical Grain--ShearForm Slab
Drawer Face, Soft Maple | ShearForm™ Drawer Fronts
(800 Series)
For horizontal grain direction use 201 DF.
For vertical grain orientation (in line with doors) order 801DF-VG.
For drawers less than 8 inches in height, veneer is applied to solid wood core. Those 8 inches or greater are built as doors with internal frame and MDF core, same as doors. |
Special attention to calling grain direction is required to avoid errors on ShearForm projects!
 |
5-Piece, Cope & Stick Drawers attain short drawer height by reducing rails to 38 mm (1 ½”) Stiles remain 2 ¼.
For taller drawers specify full width rails or order as doors. |  | 5-Piece, Standard Mitered Drawers attain short drawer height by reducing both rails and stiles to 1 ½” (38mm). For taller drawers with full width frames, order as doors. |  | Designer Miter Drawer faces each have their own particular rail profile reduced to 1 7/8" (48mm). See PROFILES section. | Notes: - 201 DF may be laminated to width.
- Minimum height for 201 DF is 3”.
- Minimum height for 5-Piece drawer fronts is 6”
- Minimum width for 5-Piece drawer fronts is 8”
- Standard grain direction is horizontal; vertical quoted upon request.
|
|
